Page Contents

 

Overview


Curvature is a texture that will effectively sample the underlying mesh for curves. A region around each shaded point gets sampled with additional rays (similar to Dirt) and all additional normals are averaged to get a "smooth" normal at the original point. This normal is used to compute the color. The color at each shaded point is a greyscale value: darker values are dents (or holes), lighter values are peaks. The parameters should be adjusted by trail and error since they generally depend on the scale used, hence the defaults might not be appropriate at all in some cases.

 

 

 

Parameters





Sample Spread – Specifies the radius of the sampled region. If a texture is selected, it will override the color as long as the texture checkbox is enabled.

Min Output Color – Specifies the minimum output color for the texture.

Max Output Color – Specifies the maximum output color for the texture.

Scale – Adjusts the scale relative to which the curvature is measured. 

Threshold – Curvature values below this threshold will be ignored and be shown as pure black. This focuses the curvature effect only around the most curved areas of the mesh. 

 

Multipliers


 

 

Mode – Specifies the multiplication mode of the colors. 

Multiplier – Multiplies the RGB numbers for each pixel of the top layer with the RGB number of the corresponding pixel from the bottom layer. The result is a darker picture. 
Blend Amount   Takes each pixel from the top layer if present. Otherwise the bottom layer is used.

Sample Spread – Controls the intensity of the Sample spread parameter.