Versions Compared

Old Version 9

changes.mady.by.user Lyubomira Toshkova

Saved on

compared with

New Version Current

changes.mady.by.user Lyubomira Toshkova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Input Parameters

...

Clip Mode (Integer) – – When set to Subtract (1), everything inside the specified mesh is clipped away (only for mesh clippers). When set to Intersect (0), everything outside the specified mesh is clipped away.

Geo (Generic Data) – Expects either a plane, a mesh, or any geometric object input (including V-Ray Geometry). A closed mesh should be used for best results. It is recommended to use native Grasshopper geometry.

Use Object Mtl.  (Boolean) – When enabled, the clipper uses the material of each clipped object to fill the resulting cuts. When disabled, the material applied to the clipper object itself is used. If no material is specified in this state, the clipped gaps remain empty.

...