Page Contents

 

Overview


The Stucco texture is a procedural texture that produces a surface effect similar to a uneven, almost dented stucco surface. Both of its color channels can be connected to texture maps if required.

 

 

Parameters


 

 

 

 

Color A – Controls the main stucco color. This channel can also be connected to a texture map, as long as the checkbox is enabled. 

Color B – Controls the stucco dot color. This channel can also be connected to a texture map, as long as the checkbox is enabled. 

Size – Controls the scale of the procedural texture produced.

Threshold – Controls which areas that will contain the textures features.

Thickness – Controls how thick the Stucco effect appears.

Color Manipulation



 

 

Invert Texture – Inverts the RGB texture values.

Alpha from Intensity – Uses the texture RGB intensity/luminance as alpha channel.

Color Gain – Corrects the color of the texture by multiplying the the RGB color values specified here with the RGB color values of the texture. When a texture is selected, it overrides the color as long as the texture checkbox is enabled. 

Color Offset – Corrects the color of the texture by adding the RGB color values specified here to the RGB color values of the texture. When a texture is selected, it overrides the color as long as the texture checkbox is enabled. 

Default Color – Specifies a default color for polygons with no valid UVs. In case the map is not tiles, the default color will be used outside the texture borders.

 


Use 3D Mapping – Enables or disables 3D mapping for the procedural texture. Note that his mode is not supported yet by the Hybrid (CUDA) engine. When this option is enabled, all Texture Placement parameters are ignored.

 

Multipliers


 

 

Mode – Specifies the multiplication mode of the colors. 

Multiplier – Multiplies the RGB numbers for each pixel of the top layer with the RGB number of the corresponding pixel from the bottom layer. The result is a darker picture. 
Blend Amount  Takes each pixel from the top layer if present. Otherwise the bottom layer is used.

Color A – Controls the intensity of the main stucco color.

Color B – Controls the intensity of the dot color.